Javascript Menu by Deluxe-Menu.com
SCHENCK SAS

HM 4 - HM 50

Horizontal Balancing Machines

  • Universally applicable
  • High balancing accuracy
  • Easy to upgrade through modular construction and a wide range of accessories
  • Hard-bearing principle ensures quick change-over from one workpiece to the next
  • CAB 700 or CAB 920 measuring instrumentation with extensive operator prompting
  • Full range of safety equipment for all protection classes

Range of application

Universal balancing machines series HM are conceived for highly precise balancing of a wide spectrum of rotors. They are suitable for balancing cylindrical rotors with integral shaft journals and for balancing disc shaped rotors on balancing arbors.

Permanent calibration, ergonomic design and a logical operating sequence facilitate operation.

Their modular design principle and a wide range of accessories make the machine highly flexible.

Schenck universal balancing machines series HM are a highly efficient investment both for one-off rotors and for small batches.

Sequence of operations

  • Manually load work-piece on the bearing pedestals, close hold-down bearings and connect drive (belt drive or drive shaft)
  • Close protection device and start automatic measuring sequence:
  • Acceleration, determination and display of the unbalance on the measuring instrument, braking. The readout is retained on the measuring instrument even after the measuring run has ended.
  • Open protection device, manually correct unbalance (if required).
  • Check correction result (with measuring instrument displaying whether the tolerance has been achieved) and unload the rotor from the machine.

Special features

  • Easy to operate – hard-bearing principle eliminates the need for calibration runs
  • Provides for correction in two planes or separate correction of static and couple unbalance
  • Rotors can be mounted on their original shafts or on mounting arbors, optionally with mounted anti-friction bearings
  • Angle indexing display in case of belt drive
  • Automatic measuring cycle with infinitely variable settings for acceleration, measuring and braking time
  • Upgradeable by many additional modules e.g. for mass correction
Informations complémentaires
Plan
1 Balancing machine2 Controls and measuring device Plan view (non-binding example)
Contact

Pour toute question, contactez svp :

Mme Claire LENOBLE

Tél.
+33 / 1 34 32 90 15
Fax
+33 / 1 34 32 35 20
E-Mail
Ajouter à la liste des produits